SonarQube 7.2, VSTS Plugin 4.3.0 stop work with Pull request

[NicoB (Nicolas Bontoux)]

Hi Petr,

There have been two kinds of error messages mentioned in this thread:

@NikitaEgorov

o To use the property “sonar.pullrequest.key”, the branch plugin is required but not installed. See the documentation of branch support: https://redirect.sonarsource.com/doc/branches.html .

(pull-request related)

And:

@rycornell

o To use the property “sonar.branch.name”, the branch plugin is required but not installed. See the documentation of branch support: https://redirect.sonarsource.com/doc/branches.html.

(branch related)

Which one are you encountering here ? If latter then as discussed it might worth following-up in this newer thread I mentioned. Specifically in light of your latest notes:

We want to analyze only one branch without pull request

How to setup analyze to another branch than master?

Below note might be insightful:

Community Edition with VSTS: To use the property "sonar.branch.name", the branch plugin is required but not installed

Thanks. The first thing I recommend checking then is that the SonarQube task (and the build definition that contains it) is only triggered on master branch. Community Edition does not support analysis of branches, so you need to make sure that SonarQube analysis only is performed on master (we’ve took a note here to make the documentation a little bit clearer in that aspect).

Which in turns means you cannot perform an analysis on another branch than master (with Git on VSTS ; related code fwiw).